Lust CDA32.006 - 4 Commissioning 1

CDA3000 Operation Manual
4-1
4 Commissioning
DE
EN
FR
IT
ES
FR
1
2
3
4
5
A
4 Commissioning
4.1 Choice of commissioning .......................................4-1
4.2 Standard commissioning ........................................4-2
4.3 KEYPAD commissioning ...........................................4-4
4.4 DRIVEMANAGER commissioning ................................4-6
4.5 Direction check .....................................................4-11
4.6 Serial commissioning ...........................................4-12
4.6.1 Serial commissioning with KEYPAD .....................4-12
4.6.2 Serial commissioning with DRIVEMANAGER ..........4-14
4.7 Operation with KEYPAD KP200 ...............................4-15
4.8 Operation with DRIVEMANAGER ...............................4-18
4.9 Parameter list (selection) .....................................4-19
Attention: Commissioning must only be carried out by qualified
electricians who have undergone instruction in the necessary
accident prevention measures.
4.1 Choice of
commissioning
Standard commissioning
The device can be put into operation with its factory
settings, without need of any other aids.
KEYPAD commissioning
The KEYPAD enables you to preset a number of basic
parameters, such as rotating field limitation (FMAX),
acceleration/deceleration ramps (ACCR/DECR) or fixed
frequencies (FFIX) etc.
DRIVEMANAGER commissioning
The “DRIVEMANAGER 3.0” PC user interface enables you
to customize your drive tasks in a user-friendly way.
Serial commissioning
To commission several identical drives, for example,
you can transfer the data set of the first drive via K
EYPAD
with S
MARTCARD or via DRIVEMANAGER to the following
drives.