4-14
CDA3000 Operation Manual
4 Commissioning
4.6.2 Serial
commissioning
with
D
RIVEMANAGER
Precondition:
• All inverter modules are fully connected.
• The first drive is already fully commissioned into operation.
• A PC with installed DRIVEMANAGER user software (V3.0 or higher) is
connected.
For more information refer to the DRIVEMANAGER Manual.
Step Action Comment
1
Connect your PC to the inverter
module of the first drive and switch
on the power to the inverter.
Use a standard serial cable (9-pin D-
SUB, socket/pin) e.g. LUST accessory
CCD-SUB90x .
2
Start DRIVEMANAGER.
Automatically links to the connected
inverter module.
If the connection fails, check the settings in the Tools > Options
menu and try again by way of icon
.
3
Save the current data set
with icon
, either in the
parameter database
(directory: c:/../userdata) of the
D
RIVEMANAGER or on a floppy disk
(a:/).
With icon the current data set of the
connected device is always saved.
Give the file a name of your choice.
4a
Disconnect from all devices
with icon
4b
Connect your PC to the inverter module of the next drive and switch on the
power to the inverter.
5
With icon establish a link
between the D
RIVEMANAGER
and the newly connected
device.
6
With icon load the data set
saved in step 4 into the
device.
The data set is stored in the device as
user data set 1.
7
With icon select the main
window.
Save the setting with
button ->
Repeat steps 4 ... 7 on each of the other drives.
Save data set from device to
file
Download data set from file
into device
Remember to save
the setting.
To Next Page
Loading...
