2-16
Example: Reduction of the base value, reset offset with RSTOP
With setting parameter applies 04-FSSEL = 17/18/19/20/21/22
Important: The braking ramp RSTOP is only active, if a value ≥ 1 Hz/s is
set in the parameter (factory setting = 0 Hz/s).
Caution: With the reduction of the base value to 0 Hz the drive comes
to a stand still, however the condition should not be confused
with a stop command. If the base value is raised while the
S2IND signal is at hand, the drive is restarted (to new base
value with old offset).
Key:
➀ Only possible with 04-FSSEL = 17/18/19/20
(Offset is retained)
➁ Only possible with 04-FSSEL = 21/22
(Offset is reset)
n
FMAX
FSIN
t
STL
S1IND
Base
(old)
Base
(new)
Offset
Base
(new)
-Offset-
1
2
RACC1
RDEC1
RSTOP
To Next Page
Loading...