Lust SMARTDRIVE VF1000 M Series - KEYPAD KP100 General Information; KEYPAD KP100 Menu Branches; KEYPAD KP100 Key Functions

4-2
4.2 In general
4.2.1 Menu branches
Once the mains is switched on, the device carries out a self-test (Display
backlit in red).
The VF1000 concludes this by jumping directly to the current value of the
output frequency (Display backlit in green).
The menu branch VAL is active. When the stop/return key is pressed
then the display changes to menu and opens the selection of further
menu branches.
VAL = Displays actual values
PARA = Change parameter setting
(parameterizing).
CTRL = Motor control via K
EYPAD
CARD = Load/save device setting with
the SMARTCARD
PARA CTRL CARDVAL
stop
return
start
enter
stop
return
start
enter
stop
return
start
enter
stop
return
start
enter
4.2.2 Key functions
The arrow keys enable the selection of
menu branches and enable their
modification.
Pressed once they cause a jump to the
next menu branch or parameter or the
smallest possible alteration of a para-
meter value.
If a key is kept pressed down, it results in
automatic run through (scrolling) which is
stopped when the key is released.
With the stop/return-key, the menu
branches are quit or parameter alterations
are interrupted (old value is retained).
With the start/enter-key, menu branches
or parameters are called up and changes
are saved.