A-6
The inverters should be protected against unauthorised loading. In
particular components may not be bent and/or insulation distances
changed during transport and use.
Inverters contain electrostatically endangered components, which can be
easily damaged when incorrectly handled. Electrical components may
not be mechanically damaged or destroyed.
When work is being carried out on live inverters, the applicable national
accident-prevention regulations (e.g. VBG 4) should be observed.
Electrical installation should be carried out according to the applicable
regulations (e.g. cable diameter, fusing, grounding cable connection).
Additional details are contained in the documentation.
Electronic devices are not intrinsically fail-safe. The user himself shall be
responsible for securing the drive if the device breaks down.
If the inverter is used for special applications (e.g. explosion-proof
area), the required standards and regulations (e.g. EN50014 and
EN50018), must be observed.
To Next Page
Loading...