Lust SMARTDRIVE VF1408M User Manual

Operation Manual
SMARTDRIVE VF1000 · Series M
Frequency inverter 1.1 to 4 kW
stop
return
start
enter
VAL
Hz
SMART
CARD
EN
ANTRIEBSTECHNIK

Lust SMARTDRIVE VF1408M Specifications

General

Type	DC Drive
Model	VF1408M
Manufacturer	Lust
Rated Output Current	8A
Cooling Method	Forced Air Cooling
Enclosure Rating	IP20
Control Method	Vector Control
Communication Interface	Modbus
Protection Features	Overcurrent, Overvoltage

Summary

SMARTDRIVE VF1000 Series M Frequency inverter 1.1 to 4 kW

4 Operating the control unit KEYPAD KP100*

A.1 Safety instructions

A.2 Intended use

A.3 Design and accessories

A.5 VF1000M with CE - acceptance test

A.6 Instructions for correct EMC installation

1 Technical data

1.2 Data table

1.4 Device assembly

2 Electrical Connections

2.1 Connection plan

Detailed diagram showing all electrical connections for mains, motor, and control signals.

2.2 Fault transmission/interference immunity (EMC)

2.3 Power connections

Mains connection

Details how to connect the inverter to the mains power supply, including voltage requirements.

2.3.2 Motor connection

2.3.4 Motor temperature monitoring (PTC/PT1 design)

2.4 Control connections

2.4.2 Function of the FSINA reference input

2.4.3 Control functions with STR/STL

2.4.4 Control function via S1IND/S2IND/S3IND

2.4.5 MOP function with S1IND/S2IND

2.4.6 Signal outputs

Analog and Digital Output Functions

2.4.7 LUSTBus connection

2.4.8 INTERBUS-S connection (Design C8)

2.4.9 CAN-Bus connection (Design C2)

3 Operating and error diagnosis

Device Status Display and Warnings

3.3 Error messages

3.4 Motor/inverter-overload protection (I * t monitoring)

4.3.2 MOP function with KEYPAD KP100

5 Parameter list

6 Parameter description

Operating Mode and Reference Input

Defines operating modes and explains the selection of different reference input types.

6.3 Frequencies

Digital Input Frequency Selection and Ramps

6.6 Special functions

Automatic Load Control (I*R-Compensation)

Explains automatic load control for constant torque and reduced motor heating.

49-SC Slip compensation On/Off

Parameter Adjustments for Compensation and Control

Current Limit and Monitoring Parameters

61-SOUTA Analog/frequency output

95-ERR1 Error 1 [Decimal-0.1h]