Lutron Electronics DO-5512SD - 8-8 Set DO salt% compensation value; 8-9 Set DO height (meter ) compensation value

2)After Display unit is selected to " C " or " F ", press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
8-8 Set DO salt% compensation value
When the lower display show " SALt "
1)This function only for the DO ( Dissolved oxygen ) mode
of adjusting the probe's salt% compensation value.
The default value is 0% salt.
2)Use the " Button " ( 3-5, Fig. 1 ) or " Button " ▲▼
( 3-6, Fig. 1 ) to select the upper value to the desired
salt% compensation value, then press the " Enter
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value temporally.
8-9 Set DO height ( meter ) compensation value
When the lower display show " High- "
1)This function only for the DO ( Dissolved oxygen ) mode
of adjusting the probe's height compensation value in
meter unit. The default value is 0 meter.
2)Use the " Button " ( 3-5, Fig. 1 ) or " Button " ▲▼
( 3-6, Fig. 1 ) to select the upper value to the desired
height compensation value ( meter ), then press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value temporally.
26