7-4 Set beeper sound ON/OFF
When the lower display show " bEEP "
1)Use the " Button " ( 3-5, Fig. 1 ) or " Button " ▲▼
( 3-6, Fig. 1 ) to select the upper value to " yES " or
" no ".
yES - Meter's beep sound will be ON with default.
no - Meter's beep sound will be OFF with default.
2)After select the upper text to " yES " or " no ", press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
Remark :
After execute the datalogger function, the buzzer sound
will off automatically to prevent any interference of
the measurement.
7-5 Set sampling time ( seconds )
When the lower display show " SP-t "
1)Use the " Button " ( 3-5, Fig. 1 ) or " Button " (▲▼
3-6, Fig. 1 ) to adjust the value ( 0, 1, 2, 5, 10, 30,60,
120, 300, 600, 1800,3600 seconds ).
Remark :
If select the sampling time to " 0 second ", it is ready
for manual Datalogger.
2)After the Sampling value is selected, press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
18
To Next Page
Loading...
Need help?
General
