Lutron Electronics vt-8204 - Change the Data Logger Sampling Time

b.Press the " Function button " ( 3-5, Fig. 1) or " Unit
button " ( 3-6, Fig. 1) to select " 1 " or " 0 ".
* If the display value show " 0 ", it will disable the Auto
Power Off function.
* If the display value show " 1 ", it will execute the Auto
PowerOff function.
c. After select the desiring value ( 1 or 0 ), press the "
Enter button " ( 3-4, Fig. 1 ) to save the data with
default.
4)
Change the data logger sampling time
a.Use the " Hold Button " to select the main function to
" SEC ".
b.Press the " Function button " ( 3-5, Fig. 1) or " Unit
button " ( 3-6, Fig. 1) to select the data logger
sampling time to 0, 1, 2, 10, 30, 60, 600, 1800, 3600
seconds.
c. After the sampling time value is determined, press the
" Enter button " ( 3-4, Fig. 1 ) to save the sampling
time with default.
5)
To show the balance data numbers in the
memory
Use the " Hold button " to select the main function to
" Cnt ".
In the same time display will show the balance data
point that exist into the memory ( allow memorize
data no. ).
19