Lutron Electronics vt-8204 - Tachometer Measuring Procedure; Clear the Existing Saving Data from the Memory; Change the Function

6) Clear the existing saving data from the memory
a.Use the " Hold button " to select the main function to
" CLr ".
b.Press the " Function button " ( 3-5, Fig. 1) or " Unit
button " ( 3-6, Fig. 1) to select " 1 " or " 0 ".
* If the display value show " 0 " , it will be not to clear
the memory.
* If the display value show " 1 " will execute the
memory clear function..
c. After select the desiring value ( 1 or 0 ), press the "
Enter button " ( 3-4, Fig. 1 ) to save the data with
default.
7)
ESC
a.Use the " Hold button " to select the main function to
" ESC ".
b.Press the " ESC button " ( 3-3, Fig. 1 ) will escape
the above advanced setting function.
5. TACHOMETER MEASURING
PROCEDURE
5-1 Change the function
1)Press the " Operation Button " ( 3-7, Fig. 1 )
continuously an not release the finger from the button.
2)Press " Function Button " ( 3-5, Fig. 1 ) momentarily in
sequence, the function will change to
20