To Next Page

To Previous Page

0698-401 MD1xL / MD2xL - 08/2020

9. Instructions for the explosion protection

9.1 ATEX-Identication

II 2G Ex h IIB T6 Gb

II 2D Ex h IIIC T80°C Db

9.2 Explosion protection regulations

► Following standards were used for the compressed air motors:

- EN 1127-1:2011 Explosive atmospheres — Explosion prevention and protection — Part 1: Basic

concepts and methodology

- EN ISO 80079-36:2016 Explosive atmospheres — Part 36: Non-electrical equipment for explosive

atmospheres — Basic method and requirements

- EN ISO 80079-37:2016 Explosive atmospheres — Part 37: Non-electrical equipment for explosive

atmospheres — Non- electrical type of protection constructional safety ‘'c’', control of ignition sources

‘'b’', liquid immersion ‘'k’'

►FollowingregulationshavetobeobservedfortheuseofequipmentinhazardousareaswithintheEU:

- DIRECTIVE 1999/92/EC on minimum requirements for improving the safety and health protection of

workers potentially at risk from explosive atmospheres

- Regulation(EC)1272/2008(CLP)

► National rules and regulations have to be observed.

9.3 Identied ignition hazards and the implemented protective measu-

res

Identied ignition hazard Implemented protective measures

Hotsurface Cooling by adiabatic expansion of the compressed air

Heatdissipationmateriallygiven

Preventingheatingofthebearingsduetospeciedreplacement

interval

Mechanically generated sparks Use of suitable materials

Discharge of static electricity Connecting the conductive housing parts to the equipotential

bonding

Constructive limitation of the electrostatic charge in plastic parts

Lutz MD2xL User Manual

Questions and Answers: