Luxman L-505uX - Page 5

3
NTEGRATED AMPL FIER L-505uX
Round pattern board
After careful consideration of delicate audio signal
flow, a round pattern board has been applied to
achieve smooth signal transmission.
Phono amplier
This unit is equipped with a phono amplifier that is
compatible with the MM/MC cartridge to achieve
analog record reproduction in a high-grade level
without adding a dedicated phono amplier.
Separate function
This unit is equipped with a separate switch to separate
the pre-amplifier and power-amplifier each other
that enables the bi-amp connection adding a power-
amplier and the coexistence with an AV system.
Loopless chassis structure
This unit consists of the independent construction
of a loopless chassis to eliminate increased ground
impedance caused by chassis current.
18 mm pitch RCA terminal
Introduction of 18 mm pitch all RCA input/output
terminals allows even a high-performance line cable
with large plug to be connected.
Large type of speaker terminals
Speaker terminals (A and B systems) of inline layout
(with same characteristics for right and left), which
is compatible with Y lugs to enable easy connection
with extra-thick speaker cables.
New standard size
This unit has been manufactured based on LUXMAN's
new standard size (440mm wide, common with a
series of separate amplifiers and a series of SACD
players.
Headphone output terminal
This terminal allows you to casually enjoy sound
even at midnight.
AC inlet
This inlet enables the connection with an external
power cable.
Needle-type meter
This unit is equipped with needle-type meters lighted
with LED, which improves the visibility in the room
where the unit will be installed.
Remote control encased in aluminum
The high-grade remote control, which is encased in
aluminum, can control applicable CD/SACD players.