BURNER MAINTENANCE & CLEANING
Your LUXOR grill is made of non-rusting, non- magnetic stainless steel. After some initial usage,
you will notice discoloration in some areas of the grill. It is a normal process caused by the
high amount of heat produced by the burners. There are many different stainless cleaners
available in the market, but be sure to use a mild cleaning product first, always scrubbing in
the direction of the grain. If there are noticeable scratches in the stainless steel, use a dry 100 grit
emery paper to sand the area. Sometimes, greasy specks collecting on the surface can look
like rust. To remove these specks, use an abrasive pad together with a stainless steel cleaner.
Remember to rub in the direction of the grain.
NOTE: The best way to maintain stainless steel is to wipe it down with a damp cloth. Excessive
moisture causes a rust-like discoloration and may eventually require replacement. Never use steel
"Brillo" pads or similar products as these will leave traces of material behind. This material will quickly
rust. This rust is not a defect in the grill.
ATTENTION
Before removing burners, gas supply must be shut off and the knobs turned to "OFF". Allow
the grill to completely cool down.
GRILL BURNERS:
BURNER CLEANING::
ORIFICE CLEANING:
To begin, remove grill racks and radiant trays. Hold the burner, pull it up and slightly to the back
of the unit. This way the burner head comes off the brass orifice at the front. Turn the burner
sideways and remove the burner. Be careful not to block or upset the air shutter position.
Use a wire brush to clean the exterior of the burner. To clear stubborn scale, use a metal scraper.
Clean any clogged ports with a straightened paper clip. Do not use a wooden toothpick as it may
break off and clog the port. Use a flashlight to check the burner inlet for possible blockage. Shake
out any debris through the air shutter. If you see any obstructions, use a metal wire coat hanger
that has been straightened out.
After the burner has been removed, remove the orifice and hold a flashlight through the opening
to check for possible blockage. Use a needle to clean any debris. use extreme caution so you
do not enlarge the hole or break off the needle.
STAINLESS STEEL U BURNER
PAGE 12
To Next Page
Loading...