EasyManua.ls Logo

Luxor 30 - Match Lighting; Manual Burner Ignition

Luxor 30
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MATCH LIGHTING
Match Lighting:
If burners do not light after several attempts, they can be match lit. If you have just
attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to
dissipate.
Grill Burners: Make sure all knobs are in the OFF position.
Rotis Burner: Make sure all knobs are in the OFF position.
Keep your face as far away from the grill as possible.
With the lid open, light a paper book match and
hold it to the ports of the burner using the lighting stick
or lighting rod attached permanently to the appliance
with a chain. Press and turn the corresponding control
dial of the burner to "lHI”.
If the burner does not light in 4 seconds, turn the
dial off and wait 5 minutes before attempting
again (see picture on the right).
With the lid open, light a, paper book match and
hold it close to the burner tiles of the Infra-Red burner.
Push and turn the Rotis control knob to "Hi" and push it in.
Hold knob in for 10 seconds after lighting and then
release. If the burner does not light in 4 seconds, turn
the knob off and wait 5 minutes before attempting it
again (see figure on right).
If the burner stays lit only while you are holding the safety
button, it may be adjusted after it has been cooled)
(as shown in figure on the right)
PAGE 16