LOCATING THE GRILL
LOCATION:
Select a suitable location for your grill by avoiding traffic paths and exposure to wind. Keep all
gas supply lines as short as possible. Do not locate the grill in a shed, the garage of a building,
storage, or other enclosed areas. To assure the unit is level front-to-back and side-to-side, use a
"spirit level". If the unit is not level the burner combustion may be erratic and the unit may not
function efficiently. If the floor is uneven or there is a slope, you may need to re-level the unit
after each moving of the unit.
FOR BUILT -IN INSTALLATIONS:
The Luxor Built-In model is designed for installation in a masonry or a non combustible enclosure.
The grill drops into the opening, and hangs from its counter top trim. There is no support required
from the bottom. Pay attention to the provisions for gas line hook-up. The enclosure must have
ventilation holes to prevent gas build-up in case of a leak. The counter top should be level and
flat. Electrical service should be provided for the units equipped with rotisserie.
- To a non-combustible construction a minimum of 5” clearance should be kept from back of
the grill. Do not locate the grill at a spot where It will be difficult to clean the exhaust and grease
from the grill.
- To a combustible construction you must keep a minimum of 16” clearance from back of the grill.
A 16” minimum clearance must also be maintained above and below the cooking surface and
in any combustible construction.
Do not build your LUXOR gas grill directly below unprotected overhead combustible construction.
CLEARANCE:
WARNING: Installing this product into a combustible enclosure could
result in fire, property damage and personal injury.
PAGE 6
To Next Page
Loading...