User Interface Commands
4-4 FOT Lab Kit User’s Manual
Parameter
Modification
This command format consists of the Escape character followed by a
two-letter command followed by an equal sign ('=') and the new
parameter value(s) and ending with a carriage return/line feed.
These commands provide the mechanism for modification of setup
parameters or for initiation of an event or sequence of events.
Example Command: <Esc>AA = E <CRLF>
If the command is successfully received, parsed and executed, the
new parameter will immediately take effect. There will be no serial-
data response from the device.
If the command is unrecognized or the command syntax or
parameter value is incorrect the system responds with the request as
typed with the addition of a question mark '?' followed by a CRLF
pair.
Information Request
Character Hexidecimal
Escape 1Bh
A 41h
A 41h
Space (optional) 20h
=3Dh
Space (optional) 20h
E 45h
Carriage Return 0Dh
Line feed 0Ah
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...