User Interface Commands
FOT Lab Kit User’s Manual 4-17
SL Signal Level
The SL command reports the relative strength of the signal arriving
at the photodetector. The signal is the intensity of light returned
from the probe tip and is reported as a percentage of maximum.
This information is used primarily during probe testing and helps to
determine whether the probe is functioning efficiently.
Information Request:
Syntax: <Esc>SL ? <CRLF>
Response: SL = signal
The signal data are returned in the same general
format as a standard temperature report.
Example:
1: 1.81 % 2: 2.66 % 3: 5.10 % 4: 3.24 %
Parameter Modification:
n/a
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...