TEXTRON
LYCOMING
OPERATOR'S
MANUAL
SECTION 3
0-360 and ASSOCIATED
MODELS
3.
STARTING
PROCEDURES
- 0-360, HO-360,
10-360,
AIO-360,
HIO-360, TIO-360 Series.
The following
starting procedures are recommended,
however, the
starting
characteristics
of various
installations
will necessitate
some
variation
from these procedures.
a. Engines
Equipped
with Float
Type Carburetors.
(1) Perform
pre-flight
inspection.
(2) Set carburetor
heat control
in "off" position.
(3) Set
propeller governor
control
in "Full RPM"
position (where
applicable).
(4) Turn
fuel valves
"On".
(5)
Move mixture control
to "Full Rich".
(6) Turn on boost pump.
(7)
Open
throttle
approximately
1/4 travel.
(8) Prime
with 1 to
3 strokes of manual
priming
pump or activate
electric primer for 1 or 2 seconds.
(9) Set magneto
selector
switch (consult
airframe
manufacturer's
handbook for correct position).
(10)
Engage
starter.
(11) When engine
fires move the magneto
switch to "Both".
(12) Check oil
pressure gage. If minimum
oil pressure is not
indicated
within thirty seconds, stop
engine and determine trouble.
b. Engines Equipped with Pressure Carburetors or Bendix Fuel
Injectors.
(1) Perform
pre-flight inspection.
(2) Set carburetor
heat or alternate
air control in "off" position.
3-2
To Next Page
Loading...