TEXTRON LYCOMING OPERATOR'S MANUAL
0-360
and ASSOCIATED MODELS
SECTION
3
(3) Set propeller
governor control in
"Full RPM" position (where
applicable).
(4) Turn fuel valve "On".
(5)
Turn boost
pump "On".
(6)
Open throttle wide open, move
mixture control to "Full
Rich"
until a slight but
steady fuel flow is noted (approximately
3 to 5 sec-
onds) then return throttle
to "Closed" and return mixture
control to
"Idle Cut-Off".
(7) Turn boost
pump "Off'.
(8) Open throttle 1/4 of travel.
(9) Set magneto
selector switch (consult
airframe manufacturer's
handbook for correct position).
(10) Engage
starter.
(11) Move
mixture control slowly
and smoothly to "Full Rich".
(12) Check oil pressure gage. If minimum oil pressure is not indi-
cated within thirty seconds,
stop engine and determine
trouble.
c. Engines
Equipped with Simmonds
Type 530 Fuel Injector.
(1) Perform pre-flight inspection.
(2) Set alternate
air control in
"Off" position.
(3) Set
propeller governor control
in "Full RPM" position.
(4) Turn fuel valve "On".
(5)
Turn
boost
pump
"On".
6) Open throttle approximately 1/4 travel, move mixture control to
"Full Rich" until a slight but steady fuel flow is noted (approxi-
mately 3 to 5 seconds) then return throttle to "Closed" and return
mixture control to "Idle Cut-Off".
Revised April
1998
3-3
To Next Page
Loading...