EasyManuals Logo
Home>Lynx>Grill>L30 Series

Lynx L30 Series Installation Use And Care Manual

Lynx L30 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
SPECIAL NOTE FOR LP USE
Never connect any unregulated
gas supply to the grill The hose
with regulator and Type 1 con
nection included with your grill
has these safety features:
The system will not allow gas to
flow until a positive connection
has been made
The system has a thermal ele
ment that will shutoff the flow
of gas between 115 and 150°C
(240 and 300°F)
The system has a flow limiting
device which, when activated,
will restrict the flow of gas to 10
cubic feet per hour
NOTE: The cylinder control valve
must be turned off before any
connection is made or removed.
NEVER USE GRILL WITHOUT
FIRST LEAK TESTING THIS
CONNECTION, FOLLOWING
THE PROCEDURE ON PAGE 11.
Should the large, black, ther
mally sensitive coupling nut be
exposed to temperatures above
115 150°C, it will soften, allow
ing the regulator probe to dis
engage from the cylinder valve,
thereby shutting off the flow of
gas Should this occur, do not
attempt to reconnect the nut
Remove the entire regulator as
sembly and replace it with a new
one The cause of the excessive
heat should be determined and
corrected before operating your
grill again The regulator probe
also contains a flowsensing el
ement, which will limit the flow
of gas to the regulator to a man
ageable amount in the event of
a hose or regulator rupture If it
is evident that the flow control
device has activated, the cause
of the excess flow should be de
termined and corrected before
using your grill again
NOTE: Improper lighting proce-
dures can cause the flow control
to activate, resulting in reduced
heat output. If this is suspected,
to reset flow control, shut off
all burner controls and cylinder
valve, wait 30 seconds, then
turn cylinder valve on extremely
slowly, wait five (5) seconds and
turn burner valve on to light
J L
F
Figure 3-1 - The included hose
and regulator must be used if
your grill is set-up for LP Gas.
Wind hitting the grill
while in use, especially
winds blowing into
or across this hood
gapl CaB cause poor
performanceand in
some casescancause
the control panel to
get dangerously hot.
Figu re :3-2 - Steady or gusty winds can prevent the normal exhaust of hot gases. Locate your grill
away from prevailing winds and avoid grilling in windy conditions. If needed, install a windbreak.
B _I-yNX 3

Other manuals for Lynx L30 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lynx L30 Series and is the answer not in the manual?

Lynx L30 Series Specifications

General IconGeneral
BrandLynx
ModelL30 Series
CategoryGrill
LanguageEnglish

Related product manuals