EasyManuals Logo

Lynx LHEM48 Care And Use Manual

Lynx LHEM48
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
P a g e | 7
Mounting Bracket Assembly
Locate and assemble the mounting brackets based on your pre-determined mounting distance to the ceiling (14” if
mounting flat, 18” if mounting at an angle). Slide the long bracket extension INSIDE the main mounting bracket until the
intended set of holes align. The entrance slot is at the bottom of the main mounting bracket. For each bracket, use
quantity (2) ¼-20 x ½” Hex Bolts (provided). Carefully insert each screw through the 2 larger holes of the main mounting
bracket and through the lower holes (for the 14” position), OR through the 2 upper holes (for the 18” position) of the
mounting bracket extension. Tighten both nuts securely. Snap the decorative cap over each larger hole of the main
mounting bracket. Repeat for other bracket. See illustration below.

Other manuals for Lynx LHEM48

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lynx LHEM48 and is the answer not in the manual?

Lynx LHEM48 Specifications

General IconGeneral
BrandLynx
ModelLHEM48
CategoryHeater
LanguageEnglish