P a g e | 12
Touch Screen Remote Transmitter-remove the cover on the back of the remote control unit and install (4) AAA 1.5 V
batteries. Take special note of the (+) and (-) terminals.
Heater- remove the (2) screws holding the louvered end plate at the far, right end of the heater. This is the SMALLER of
the 2 access plates. The battery pack will be mounted directly inside, and onto the endplate. Carefully lift the (black)
sealed pack out from the retaining clip. Remove the vinyl sleeves that cover the battery pack. Insert (4) AA 1.5 V
batteries taking special note of the (+) and (-) terminals. Reinstall the vinyl sleeves over the battery pack, and place the
battery pack back into the retaining clip. Leave the louvered end plateoff and let it hang straight down for the next
programming operation. See pictures below.
Battery Installation in Heater
Remove screws from right end Access Cover Lift Access Cover away from heater
Remove Battery Pack from Access Cover Remove Vinly Sleeves from Battery Pack
To Next Page
Loading...
Need help?
General