WARNING
STATE OF MASSACHUSETTS:
WARNING - ELECTRICAL GROUNDING
iii
1. This gas appliance and its individual shutoff valve must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressures in excess of
1/2 psi (3.5 kPa).
2. This gas appliance must be isolated from the gas supply piping system by closing its individual
manual shutoff valve during any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa).
1. Massachusetts requires all gas be installed using a plumber or gas fitter carrying the
appropriate Massachusetts license.
2. All permanently-installed natural gas or propane installations require a “T” handle type
manual gas valve be installed in the gas supply line to this appliance.
3. This does not apply to portable propane installations using a 20 pound cylinder.
• Product installation must meet local electric codes or, in the absence of local codes, the
latest edition of the National Electrical Code ANSI/NFPA No. 70 or the Canadian Electrical
Code CSA C22.1.
• Use only a Ground Fault Interrupter (GFI) protected circuit when plugging in the AC
adaptor of this appliance.
• This appliance is equipped with a low voltage, AC adaptor. All connecting cords must be
for outdoor use and contain three prong (grounded) electric plugs for your protection
against shock hazard. Cords must have a “W-A” marking, and must be plugged directly
into a properly grounded three prong outlet. Never cut or remove the grounding prong
from this plug.
• To protect against electric shock, do not immerse any part of the extension cord or any
plugs in water or other liquid.
• Unplug the AC adaptor from its power source when long periods of time are anticipated for
the appliance to be out of use.
• Do not let the extension cord hang over the edge of a table or touch hot surfaces.
• Do not operate any outdoor appliance with a damaged cord, plug, or after the appliance
malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
SPRINKLERS: This appliance must be located at an appropriate distance away from fire sprinklers
(4ft min. recommended) to avoid accidental activation of sprinkler. Ethylene glycol or propylene
glycol must never be used in fire sprinkler systems where heaters are present, as these substances
may become flammable when heated. A fire sprinkler professional must be consulted when heaters
are installed where fire sprinklers are present to insure that heaters and fire sprinklers are properly
integrated. Specific guidelines can be found in NFPA 13 regarding design and specifications for fire
sprinkler systems near heaters.
To Next Page
Loading...
Need help?
General