26
LEDs
This section allows you to adjust LED settings for any LED on the hardware. The selected LED is highlighted, and the info
shows data about that LED (if applicable, for instance with buttons).
Sample button LEDs have an extra control of UNASSIGNED, allowing you to select color and LED type for its unassigned
state. LEDs not connected to buttons can only assign inactive or active.
UNASSIGNED, INACTIVE, and ACTIVE can have three types of buttons - SOLID, PULSE, or RAINBOW. If a state choice is
set to SOLID, there is one color picker available. When clicked on, a context menu with color swatches appears. If a state
choice is set to PULSE, the LEDs will pulse uniformly. You can select up to a maximum of 4 LED colors to pulse between.
These colors will go in order from 1-4, and then repeat starting at 1. If the state choice is RAINBOW, it will activate the
rainbow effect. The button will color cycle through the entire spectrum of available LED colors. Selecting Rainbow will allow
you to select Default for standard LED brightness, Dark 1 or Dark 2 for darker LED brightness or Bright 1 or Bright 2 for
brighter LED brightness.
To Next Page
Loading...
