29
Stream
5.
GAME Level Fader: This fader will adjust the volume of the game audio being sent to the
USB port, Headphone, and Main Outs. This level will be identical to the audio that is being
sent to the headphones unless the headphone/speaker mix is changed in the M-Game's
software's Routing tab.
6.
“GAME” Mute Button: This backlit button will mute the game audio signal being sent to the
USB port, Headphone, and Main Outs. Use the M-Game software to change the LED
behavior of this button seen in the LEDs section. By default this LED will be brightly lit when
Mute is active and dimly lit when Mute is inactive.
7.
CHAT Level Fader: This fader will adjust the volume of the chat audio being sent to the
USB port, Headphone, and Main Outs. This level will be identical to the audio that is being
sent to the headphones unless the headphone/speaker mix is changed in the M-Game's
software's Routing tab.
8.
CHAT Mute Button: This backlit button will mute the chat audio signal being sent to the USB port, Headphone, and
Main Outs. Use the M-Game software to change the LED behavior of this button seen in the LEDs section. By default
this LED will be brightly lit when Mute is active and dimly lit when Mute is inactive.
9.
SAMPLER Fader Level: This fader will adjust the volume of the sampler audio being sent to the USB port,
Headphone, and Main Outs. This level will be identical to the audio that is being sent to the headphones unless the
headphone/speaker mix is changed in the M-Game's software's Routing tab.
10.
SAMPLER Mute Button: This backlit button will mute the sampler audio signal being sent to the USB port,
Headphone, and Main Outs. Use the M-Game software to change the LED behavior of this button seen in the LEDs
section. By default this LED will be brightly lit when Mute is active and dimly lit when Mute is inactive.
11.
System/AUX Level Fader: This fader will adjust the volume of the system and AUX input audio being sent to the
USB port, Headphone, and Main Outs. This level will be identical to the audio that is being sent to the headphones
unless the headphone/speaker mix is changed in the M-Game's software's Routing tab.
12.
System/AUX Mute Button: This backlit button will mute the system audio and AUX signal being sent to the USB
port, Headphone, and Main Outs. Use the M-Game software to change the LED behavior of this button seen in the
LEDs section. By default this LED will be brightly lit when Mute is active and dimly lit when Mute is inactive.
Voice FX
13. VOICE FX: Triggers a voice effect which can be assigned in the M-Game software seen in the Effects
section.
Samples
14. SAMPLE Bank: Toggles between the 2 sample banks. The total amount of samples per bank is 3,
for a total of 6 samples.
When this button is pressed and held, the Sample buttons can be pressed to delete the currently
assigned sample. When the Sample buttons are in delete mode, press one to remove the current
sample(s) assigned to that button.
15. SAMPLE 1-3: Press these to trigger an assigned audio sample from the M-Game software.
When one of these buttons is pressed and held and no sample is assigned to the button, it will
trigger the M-Game software to start recording a sample from the incoming audio signal. The audio
sent to the Sampler can be configured via the M-Game software and seen in Sampler section.
5
6
7
8
9
To Next Page
Loading...
