30
Rear Panel
1. GAIN: Controls the XLR In or Mic In gain. Input gain is controlled
using the mic Gain knob. To set the input gain correctly, use the
M-Game software's Set Mic seen in the Software Setup section.
2. XLR IN: Connect an XLR microphone here.
If your mic requires phantom power, turn on +48V phantom power
from the M-Game software.
3. MIC IN: Connect a gaming headset mic to this input.
If a TRS input is connected, this overrides the XLR mic input.
Input gain is controlled using the mic Gain knob.
To set the input gain correctly, use the M-Game software's Set Mic seen in the Software Setup section.
4. HP OUT: Connect headphones to this output.
5. MAIN OUT: Connect speakers to this 1/8” (3.5 mm) stereo TRS output.
6. AUX IN: Connect an MP3 player or smartphone to this 1/8” (3.5 mm) stereo Aux input.
7. FOOTSWITCH: Connect a 1/4” (6.35 mm) TRS non-latching momentary dual footswitch or TS
single footswitch here to assign a function in the software control panel, such as triggering mute
or activating an effect or a sample.
8. CONSOLE: Connect a gaming console or television here that uses an Optical Digital Audio
(PCM type) output to capture and stream its audio.
9. USB: Connect your streaming computer here to capture and stream audio from M-Game Solo's
microphone inputs, game audio, chat audio, and the aux input using the M-Game software.
10.
Power Input: Connect the included power adapter here to power M-Game Solo.
11. POWER: Turns M-Game Solo on or off.
1/4” (6.35 mm)
TS
1
4” (6.35 mm)
TRS
1
2
3
4
5
6
7
8
9
To Next Page
Loading...
Need help?
General
