Oxygen Keyboard Line User Guide
11
English
Control Select
The Control Select function selects a MIDI controller for parameter editing. Use the Control Select function to select a MIDI controller
before assigning a MIDI CC number to that controller.
To select a MIDI controller for editing, move the knob or fader that you want to edit. The last used controller is always the controller
that is currently selected for editing.
The second method to select a MIDI controller for editing:
1. Press the Advanced Function button
2. Press the Control Select button
3. Enter the controller’s ID number using the data entry keys.
4. Press the Enter key to confirm.
Note: If you move a controller after pressing Control Select, the LED will display the ID number of the selected controller to edit. The
ID number of each controller is shown on the printing by each control.
Program
The Program function is used to send a Program Change on the Global Channel. To send a Program Change:
1. Press the Advanced Function button.
2. Press the Program key.
3. Enter the Program Change to send using the data entry keys.
4. Press the Enter key to confirm.
Note that it is also possible to set the data keys to control Program Change. To do this:
1. Press the Select Function button until the dot above Prog is lit.
2. Use the - and + Data buttons to step through Program Changes. The Program Change number shown in the LED display will
be sent.
Bank LSB
The Bank LSB function can be used to access additional banks of sounds on your sound module or sound card by sending a bank
change LSB message. Note, this is only possible if your receiving device has additional banks of sounds.
1. Press the Advanced button.
2. Press the Bank LSB key.
3. Enter the bank number using the keypad.
4. Press the Enter key.
Please check your receiving device’s documentation to ensure that it will respond to these messages.
The Bank MSB message is always sent on the Global Channel.
Bank MSB
The Bank MSB function can be used to access additional banks of sounds on your sound module or sound card by sending a bank
change MSB message. Note: this is only possible if your receiving device has additional banks of sounds.
1. Press the Advanced button.
2. Press the Bank MSB key.
3. Enter the bank number using the keypad.
4. Press the Enter key.
Please check your receiving device’s documentation to ensure that it will respond to these messages.
The Bank MSB message is always sent on the Global Channel.
Data 1
The Data 1 function key only applies to the unit’s programmable buttons and pedal. The function of Data 1 depends on the MIDI CC
that is currently assigned to the controller that is to be edited. Please refer to Appendix A where each assignable MIDI CC is listed,
along with the Data 1, 2 and 3 functions.
When editing Data 1 values, the range of values that can be selected is 0-127.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
