Oxygen Keyboard Line User Guide
13
English
Velocity Curve
The Velocity Curve Select button selects the velocity curve that the keyboard will use to regulate each MIDI note. Oxygen controllers
offer 12 different velocity curve settings, 9 curves, and 3 fixed curves. The 3 fixed curves give velocities of 64, 100 and 127.
On the Oxygen keyboard:
1. Press the Advanced Function button.
2. Press the Velocity key.
3. Type the number of the desired velocity curve using the key pad, and press the Enter key.
Drawbar Mode (49- and 61-note only)
The Drawbar function reverses the polarity of the faders.
1. Press the Advanced Function button.
2. Press the Drawbar key.
To exit the Drawbar function, press the Drawbar button a second time.
Device ID (49- and 61-note only)
The Device ID function will allow the assigning of a Device ID to differentiate between multiple keyboards when sending a memory
dump. On initial power up, the Device ID for your Oxygen keyboard is 127, meaning the device will respond to any SysEx received
regardless of the Device ID setting. If a Device ID is set at a number other than 127, the device will not respond to SysEx messages that
do not have a device ID of either 127, or the same as the device.
1. Press Advanced Function button and then the Device ID key.
2. Enter new device number on keypad.
3. Press the Enter key.
When engaging the Device ID function, the last saved device id number will display on the LED screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
