M-Audio Venom

Chapter 3: Using Venom Standalone
19
Venom User Guide
Saving Multi Programs, Parts, and Patterns
To save the current settings of a Multi Program:
1 Ensure that the Multi button LED is lit and that you have been editing a Multi Program.
2 Press the Store button. The Multi button and the Store button LEDs start flashing.
3 If desired, select a new storage location for the Multi Program:
• Press the Bank button to select the Bank where you want to save the current settings for the Multi Pro-
gram.
• Adjust the Value knob to select the preset location where you want to save the current settings for the
Multi Program.
4 If desired, rename the Multi Program:
• Press the OCTAVE + button. In the Venom LCD, the first character of the program name starts flashing.
• Use the Value knob to change the character.
• Press OCTAVE + button to move to the next character to the right for editing.
• Use the OCTAVE – button to move back to the next character to the left for editing.
5 Press the Store button to save the Multi Program settings to the selected Bank and preset location.
To save the current settings of a Multi Part:
1 Ensure that you are in Multi mode.
2 Press the Store button.
3 If desired, select a new storage location for the Multi Part Single Program:
• Press the Bank button to select the Bank where you want to save the current settings for the Multi Part
Single Program.
• Adjust the Value knob to select the preset location where you want to save the current settings for the
Multi Part Single Program.
4 If desired, rename the Multi Part Single Program:
• Press the OCTAVE + button. In the Venom LCD, the first character of the program name starts flashing.
• Use the Value knob to change the character.
• Press OCTAVE + button to move to the next character to the right for editing.
• Use the OCTAVE – button to move back to the next character to the left for editing.
5 Press the Store button to save the Multi Part Single Program settings to the selected Bank and preset location.
This process involves a Single Program within a Multi Part. It will be stored in one of the Single Program
User Banks, and it may affect references in the current Multi Part or others.