4
Precautions for use and safety
CONNECT CABLES AND CONNECT CABLES AND
INPUT/OUTPUT JACKSINPUT/OUTPUT JACKS
Always turn off all equipment, be-
fore connecting cables.
Always unplug all connection ca-
bles and the AC adapter before
moving the unit.
Connect the device only to instru-
ments that comply with the safe-
ty requirements of the applicable
harmonized technical product
standards. Connect the connecting
cables to the auxiliary accesso-
ries in such a way that they do not
present the danger of pulling down-
ward due to possible unintentional
bumping, in order to eliminate the
risk of the device falling down.
PRECAUTIONS FOR USE. PRECAUTIONS FOR USE.
INTERFERENCE WITH OTHER INTERFERENCE WITH OTHER
ELECTRICAL EQUIPMENTELECTRICAL EQUIPMENT
B.BEAT equipment complies with the
essential requirements of Annex I of Di-
rective 2014/35/EU (Electromagnetic
Compatibility Directive). In particular, the
equipment is designed and manufactured
on the basis of technological progress, so
that:
a) the electromagnetic disturbance pro-
duced does not exceed the level above
which radio and telecommunications
equipment or other equipment cannot op-
erate normally;
b) exhibit a level of immunity to foresee-
able electromagnetic disturbances based
on the use for which they are intended
that allows their normal operation with-
out unacceptable deterioration.
However, equipment susceptible to inter-
ference or emitting powerful electromag-
netic waves could cause interference if
placed nearby. In such a case, place the
other device away from each other. With
any kind of digitally controlled electronic
equipment, including, electromagnetic
interference can cause malfunction, dam-
age and destroy data, and create troubles.
Be careful
CLEANINGCLEANING
Use a soft, dry cloth to clean the unit. If
necessary, slightly moisten the cloth.
Do not use abrasive cleaners, waxes or
solvents, including alcohol, benzene and
paint solvents.
MALFUNCTIONSMALFUNCTIONS
If the unit breaks down or fails to work,
unplug the AC adapter immediately, turn
off the unit and disconnect the other ca-
bles. Contact the distributor from whom
you purchased the unit or a
B.BEAT service center with the following
information: product model, serial number
and detailed symptoms of error or mal-
function, along with your name, address
and telephone number.
To Next Page
Loading...