19
Check me!
Place the template in the corner of the shower where
you want to install your shelf.
Slide the template up until the points on the left and
right-hand side of the template are at the height you
want your shelf.
Use a pencil, marker or wax pencil to mark the spots
where the holes for the shelf will be drilled.
Drill the holes using a 9/64" drill bit.
8
STEP Marking and drilling the
glass shelf holes
Fold here
Drilling positions
?
?
?
?
90°
Quick tip
Apply masking tape on both sides
of the joint where you will run a
bead of silicone. Apply the silicone,
smooth with a wet nger then
remove the masking tape.
Check me!
Apply a bead of silicone all along the wall to wall
and wall to base joints. For a smooth nish you can
remove the silicone excess with a damp rag or wet
nger.
9
STEP Silicone
All faucets installed on the walls
must be sealed with silicone.
Remove protective lm from walls
To Next Page
Loading...