23
when the remaining water is frozen
1. Pour warm water NOT EXCEEDING 50 °C into the washing tub to
soak it completely.
2. Use your hands to gently turn the pulsator. Be very careful.
3. Make sure the drainage works normally before operating the
washing machine.
prevent freezing of the washer
1. Make sure all water has been completely drained from the wash-
ing machine after using it.
2. After completely draining the water, set the WASH TYPE selector
in the DRAIN position. If left at the NORMAL position it will be
rather difficult for the frozen water to melt.
2 - 3 liters of water
NOT EXCEEDING
50 °C
cleaning the unit
• Completely wipe the unit using a damp soft cloth.
• If the washing machine is very dirty, wipe it with a neutral deter-
gent.
• Do not wash the machine by spraying water directly on it.
• After washing, disconnect the water supply hose.
• Do not store water in the tub for long periods. Discharge the wa-
ter immediately after each use.
• Pull off the power plug and hang up the power cord.
• Hang up the drain hose. Wipe off the water drops on the surface
of the machine and inside the tub using a clean soft cloth.
• Leave the cover of the washing tub and the inner and outer covers
of the spinning tub open for about an hour, then close them.
To Next Page
Loading...
Need help?
General
