15
Press down
spin cap
Correct
position
Unbalanced
load
Press down
Correct Without
spin cap
spin
1. Distribute the load into the spin tub evenly and smoothly.
Properly place the spin cap, even when the load size is small.
2. Spin the load.
3. Close both the interior and exterior lids of the spin tub.
4. Spin the load for 1-2 minutes.
Exterior lid of
the spinning
tub
Interior lid of
the spinning
tub
run a foam-removing spin
1. Open the exterior lid of the spin tub.
2. Set the water inlet selector control at the SPIN position. Let the
tub fill with water for about 1 minute. If the water flow rate is
too high, the water may flow out from the wash tub side. Adjust
the water tap to limit the water filling.
3. Close the exterior lid of the spin tub. Spin for 1-2 minutes.
wash spin
To Next Page
Loading...
Need help?
General
