19
2 - 3 liters of water
below 50 °C
cleaning the unit
• Wipe the entire unit using a soft moist cloth.
• Use a neutral detergent, if the machine is very dirty.
• Do not use water directly when cleaning.
• After washing, disconnect the water inlet hose.
• Do not let water stand into the machine for long periods of time.
Drain the water immediately after each use.
• Disconnect the power plug and hang up the power cord.
• Hang up the drain hose. Wipe off water drops from the surface of
the washer and inside the machine using a clean soft cloth.
• Leave the washer lid open, as well as the exterior and interior lids
of the spin tub for a short period of time (about one hour), then
close them.
if water freezes inside the tub
1. Pour hot water (BELOW 50 °C) into the wash tub to soak it com-
pletely.
2. Using your hands, gently turn the pulsator.
3. Confirm that the drainage function is operating normally before
next use.
prevent freezing
1. Be sure to drain the water completely after each use.
2. After complete the drain, set the DRAIN SELECTOR knob to the
OFF position. If the selector is set to the DRAIN position, it will be
difficult for the frozen water to melt.
To Next Page
Loading...
Need help?
General
