Mac allister MHTP24EB - Page 15

Product functions
MHTP24EB by MacAllister
GB
IE
In more detail...
15
Cutting
> Pressthethrottleinterlock(13),holditinpositionandthenpress
the throttle trigger (12) to engage the cutting device.
> Release the throttle trigger (12) to stop the cutting device (4).
Stopping
> Release the throttle trigger (12) and let the
product run at its idle speed for 10 – 15
seconds.
> Set the ignition switch (14) to its off position
“O” (Fig. 12).
WARNING! The cutting device will continue to move for
some time after the engine has been switched off! Wait
until cutting device has come to a complete stop before
placing the product on the ground!
Fig. 12
Fig. 12