34 35
MLMP300H40 MLMP300H40
In more detail . . .
In more detail . . .
Cleaning
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for areas
that are hard to reach.
2. In particular, clean the air vents (8) after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
4.
Clean the underbody and cutting means (24) using the water hose connector (12).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
Maintenance
Before and after each use, check the product and accessories for wear and damage.
If required, exchange them for new ones as described in this instruction manual.
Observe the technical requirements.
WARNING! It is required to tip the product when performing the maintenance.
explosion.
NOTE: Always empty the fuel tank and keep the spark plug upside down.
(10a)/spark
After use
1.
Stop the engine, disconnect the spark plug connector (13) and let the product cool.
2. Check, clean and store the product as described in the maintenance table.
6.
cut a row or two around the circumference of the bed.
7. Pay particular attention when changing direction.
8. Empty the grass catcher (20) regularly.
WARNING! Extensive vibration of the product during operation is an indication
of damage! Stop the engine immediately. The product should be promptly
inspected and repaired!
The golden rules for care
DANGER! Proper maintenance is essential for safe and trouble free operation.
Improper maintenance, or failure to address a problem instantly can cause
a malfunction which can result in serious injury or even death.
WARNING! Stop the engine, disconnect the spark plug connector (13) and
let the product cool before performing inspection, maintenance and cleaning
work!
Do not touch the rotating blade (24).
1. Keep the product clean. Remove debris after each use and before storage.
2. Regular and proper cleaning helps to ensure safe operation and prolongs the life
of the product.
3. Inspect the product before each use for worn and damaged parts. Do not operate
an authorised service centre for repair before using the product again.
WARNING! Only perform repairs and maintenance work according to these
Operation / Care and maintenance Care and maintenance
To Next Page
Loading...
