38 39
MLMP300H40 MLMP300H40
In more detail . . .
In more detail . . .
12
28
3.
4. When the grass clippings stop coming out of the underbody, stop the engine.
5.
Turn off the water supply and detach the water hose from the water hose connector
(12).
6. Start the engine and let it run for 2 minutes to dry the underbody.
Grass catcher
1.
Inspect the grass catcher (20
2. Clean the grass catcher (20) after operation using water.
3. Let the grass catcher (20) dry thoroughly before storing.
Brake wire
Check the performance of the brake wire (5
to adjust it if necessary.
WARNING! Do not use the product with a defective or loose wire!
NOTE: Replace the cutting means (24) after 50 hours of mowing, or 2 years
whichever is sooner regardless of condition. If the cutting means (24) is
cracked or damaged, replace it immediately.
7.
Lubricate the cutting means (24) after each use to prolong their life span. Apply
lubrication oil/grease along the edges of the cutting means (24).
24a
24b
24
24d
24e
24c
Torque wrench
(40 - 45 Nm)
27
Underbody and cutting means cleaning
NOTE: Do not use pressure washer for cleaning. It may force water to enter
the vital areas of the product.
1. Set the cutting height to the lowest position using the lever (17).
2.
Connect a water hose with a quick connector to the water hose connector (12)
(Fig. 28). Turn on the water supply.
NOTE: A quick connector must be used to connect the water hose and the
connector (12).
Care and maintenanceCare and maintenance
To Next Page
Loading...
