OM-154 500 Page 6
SECTION 3 – OPERATION
MOVING PARTS can cause injury.
• Keep away from pinch points such as drive rolls.
• Keep all doors, panels, covers, and guards closed
and securely in place.
ARCING can damage switch.
• Do not change Voltage Adjustment switch position
while welding.
Arcing inside switch can damage contacts, causing
switch to fail.
READ SAFETY BLOCKS at beginning
of manual before proceeding.
WARNING
1
1 Insulating Gloves
2 Safety Glasses With Side
Shields
3 Welding Helmet
Wear dry insulating gloves, safety
glasses with side shields, and a
welding helmet with a correct shade
of filter (see ANSI Z49.1).
2 3
sb3.1 10/91
Figure 3-1. Safety Equipment
To Next Page
Loading...