MAC TOOLS SPL2500M - Additional Safety Information; Intended Use; Specifications

3
ENGLISH
Additional Safety Information

WARNING: Never modify the power lamp or any part
of it. Damage or personal injury couldresult.
• An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The
smaller the gauge number of the wire, the greater the
capacity of the cable, that is, 16gauge has more capacity
than 18gauge. An undersized cord will cause a drop in
line voltage resulting in loss of power and overheating.
When using more than one extension to make up the
total length, be sure each individual extension contains at
least the minimum wire size. The following table shows
the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier
gauge. The lower the gauge number, the heavier thecord.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
(meters)
120V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere Rating
American Wire Gauge
More
Than
Not
More
Than
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Recommended
Use of Extension Cords with Area Light
Only use a grounded extension cord that is rated at least
12amps and has a third-wireground.
When a long extension cord is used to connect a area light
or tool, a voltage drop occurs. The longer the cord, the
greater the voltage drop. This results in less voltage being
supplied to the area light or tool and increases the amount
of current (amp) draw or reduces performance. A heavier
cord with a larger wire size will reduce the voltage drop. Be
sure to choose a cord that will supply enough voltage to
operate your tool and/or task light.

WARNING: Risk of electric shock. Keep extension cord
connection dry and off theground.

WARNING: Keep electrical cords in good condition.
Do not use worn, bare, or frayed cords because they
can cause electricalshock.

WARNING: Operating equipment at low voltage
can cause it to overheat. Using an excessively long
extension cord can cause the cord tooverheat.
For more information about extension cord size
requirements, refer to the Minimum Gauge for Cord Sets
chart found under Aditional SafetyInformation.
Specifications
SPL2500M
Voltage V
AC
120
Battery type Li-Ion
Power bank output voltage V
DC
5
Power bank output ampere A 1
Lumens** lm 500/1000/2500
Ingress protection rating IP67
Impact protection rating IK07
Charging conditions 32 °F–104 °F
(0 °C–40 °C)
Operating conditions 32 °F–104 °F
(0 °C–40 °C)
Storage conditions 14 °F–104 °F
(-10 °C–40 °C)
Weight 3.1 lbs (1.4 kg)
** Operating the light in high ambient temperatures may result in reduced
lumen output.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Intended Use
This area light is designed for workplace lightinguse.
DO NOT use under wet conditions or in presence of
flammable liquids orgases.
DO NOT let children come into contact with the lamp.
Supervision is required when inexperienced operators use
thislamp.
The label on your lamp may include the followingsymbols.
The symbols and their definitions are asfollows:
Read instruction manual beforeuse.
European certification
Class 3luminaire appliance
Canadian Standards Association, independently
tested and certified.
Waste electrical and electronic equipment:
SeparateCollection.
Keep clear ofmagnets.
Magnetic hazard can disturb pacemaker
operation and result in serious injury ordeath.
Hot surface
• The temperature of the aluminum case inside the
bumper is high. Take care to avoid coming into contact
with the hotsurface.