User guide HC - Copyright © 2008 MAC3. All right reserved.
Disegno 6328
17
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
If pumps are on, HC SLAVE displays the following message:
ONLY FOR THREE PHASE PUMPS
check the correct sense of rotation of the pump. If you want to change:
o press key + for about 5 seconds
o With key --> go to the parameter Rotation Sense.
With key + and – set the value desired for rotation sense(0000 or 0001)
o Press ENTER, and keep pressed till it will be displayed “Done.…………”.
SLAVE2
ON F=1 30.00 Hz
ON F=1 35.00 Hz
To Next Page
Loading...
