MAC3 HydroController HCW MT 1P - English

User guide HC - Copyright © 2008 MAC3. All right reserved.
Man 01
Disegno 6328
15
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
En
glish
Garden Mode OFF
 Displayed System Pressure
h. Press + or – to change the value (from 1.00 to 7.50).
i. insert the value for desired pressure of the system
j. Press ENTER, and keep pressed till it will be displayed “Done.…………”.
 Displayed System Start
a. Press + or – to change the value (ON/OFF):
ON to active the pump
OFF not to active the pump
b. Press ENTER, and keep pressed till it will be displayed “Done.…………”.
 Displayed Save & Exit With ENTER
a. Press ENTER, and keep pressed till it will be displayed “Done.…………”.
 Displayed Saving Parameter and the DONE All the paramenters are saved in
permanent memory.
Warnings: IF System Start = ON, HydroController immediately
powers the electro-pump!
System Pressure
3
,
50
Bar
System Start
OFF
Save & Exit
With ENTER