User Guide HC - Copyright © 2008 MAC3. All right reserved.
Disegno 6328
34
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
SLAVE1
..............
This is the standard visualization of the display for
hydrocontroller set as SLAVE
NB:. Only for HCMT:
If the device has been activated, check the sense of rotation of the pump;
if must modify the sense of rotation press key + for about 5 seconds, with key --> go to the
parameter Rotation Sense. With key + and – set the value desired for rotation sense(0000 or
0001)
Press ENTER, and keep pressed till it will be displayed “Done.…………”.
At the end of start up procedure :
MASTER displays, in cyclical way, the following messages.
State of the group
X.XX At Hydroc : display the pipeline pressure
Hereafter are indicated the following parameters:
ON/OFF state of the group switch off or active
00000 Watt power supply consume in Watt
State of the Master
X.XX At Master : display the pipeline pressure.
Hereafter are indicated the following parameters:
OFF/ ON state of the MASTER switch off or active
F= 1/0 check if there is flow
XXX.XX HZ frequency for the pump connected to the Master.
State of the Slave Y (1 o 2)
X.XX At SlaveY : display the pipeline pressure.
Hereafter are indicated the following parameters:
OFF/ON state of the SlaveY switch off or active
F= 1/0 check if there is flow
XXX.XX HZ frequency for the pump connected to the Slave Y.
Not connected: shows that the Slave Y is not connected.
SLAVE displays the following messages.
State of the Slave Y (1 o 2 )
Hereafter are indicated the following parameters:
OFF/ON state of the SlaveY switch off or active
F= 1/0 check if there is flow
XXX.XX HZ frequency for the pump connected to the Slave Y.
Not connected: shows that the Slave Y is not connected.
X.XX AT Hydroc
X.XX AT Master
ON/OFF F=1/0 XXX.XX
X.XX AT Slave Y
Slave Y
To Next Page
Loading...
