Macas MACES4C-00 - Tests

MACES4C-00 Operator UI manual 13
Default:2s
Dosage
The powder amount to do the "Sample dosage" test.
Default:5g
Speed for calibration
Speed to do the calibration.
Default:45
Mixer
Watitime
Wait time before dosage powder.
Default:0s
Rotation speed
Motor speed
Default:60
Turnaft time
Run the mixer motor for a few seconds after the
water pump stop.
Espresso boiler
Speed gearpump
Gear pump speed.
Boiler temperature setting
Temperature for the boiler.
Boiler delta temp first cup
The boiler rise for how many degrees for the first cup
product.
Grinder
Test dosage
Test dosage amount.
Valve array
Close delay
Valve closes delay time.
Cup dispenser
Dispmotor speed
Cup dispenser motor speed.
Default:40
Drummotor speed
Drum motor motor speed.
Default:25
Cup table
Speed catcher
Cup catcher motor speed.
Default:30
4.1.2 Tests
Note: canister and grinder has calibration function. Please refer to JLES4C ESFB Service manual 5.12
machine setting up for further information.
Comp. type
Tests
Remark
Cannister
Sample dosage
Dispenser the setting powder amount in "Dosage".
Motor test
Run motor for a few seconds.
Dosage test
Dosage powder in a fix speed which is setting in
"Speed".
Calibration
Do calibration for cannister.
Sample dosage
Dispenser the setting powder amount in "Dosage".
Mixer
Test mixer
Run mixer motor for a few second.
Connection test
Test if mixer motor is connected.
Mono brewer
Test brewer
Run mono brewer all movement.
Brewer service mode
Brewer go to service mode.
Espresso brewer
Test Brewer
Test esbrewer movement.
Brewer to dosage
Esbrewer goes to dosage position.
Brewer press
Esbrewer goes to press position.