Why is there feedback when the microphone is turned up on my Mach M-Flex 12 Printer?
Feedback can occur when microphones are turned up because they have different characteristics depending on their intended use. Ensure that you are using a vocal microphone with a Cardioid (unidirectional) characteristic. Also, try turning the microphone away from the speaker and reduce bass and treble EQ.
What to do if my Mach M-Flex 12 Printer has distorted sound, but the peak indicator isn't on?
If you are experiencing distorted sound without the peak indicator illuminating on your Mach Printer, it's possible that the mixer or another audio source is overdriven or clipping. Try turning down the signal from the source to resolve this issue.
How to fix a Mach M-Flex 12 with no sound?
First, ensure that all XLR cables are wired according to the AES standards: Hot (+) - Pin2, Cold (-) - Pin3, and Shield (ground) - Pin1. Also, check that the signal is strong enough, as a weak signal may cause the unit to shut down if the stand-by function is enabled.
What to do if there is no sound when connecting a microphone to the mic input of my Mach Printer?
If you're not getting any sound when connecting a microphone to the mic input on your Mach Printer, it might be because the microphone requires phantom power. Try switching to a dynamic microphone instead.
How to resolve low input signal on Mach Printer?
To address a low input signal on your Mach Printer, ensure that the input cables are balanced.
General safety precautions for operating the M•Flex speaker system.
Details the Neutric PowerCon plug and connection requirements for power.
Instructions on turning the M•Flex speaker on and off.
Explains the meaning of the front and rear panel LED indicators.
Describes the XLR microphone input and its compatibility.
Explains how to switch the input between microphone and line level signals.
General| Print Resolution | 203 dpi |
|---|---|
| Print Speed | 6 inches per second (152 mm per second) |
| Connectivity | USB, Serial, Ethernet |
| Print Technology | Thermal Transfer |
| Max Print Width | 104 mm (4.09") |
| Supported Media Types | Wristbands |
| Maximum Print Width | 104 mm (4.09") |
To Next Page