8
Rear panel interfaces
R
EAR
PANEL
INTERFACES
2
This section describes the rear panel interfaces.
POWER SECTION
Power input
The enclosed power cable features a Neutric PowerCon plug. The PowerCon plug is
locked into the socket thus eliminating the risk of accidentally having the main
power connector pulled out of the socket.
Note: Remember to bring the cord at all times, as it is a custom
component often not yet found in normal electrical components.
Connect the power Plug in the power cord to an AC socket with a voltage, which
correspond to the amplifier current (110 or 220 volt depending on model – refer to
the M•Flex label on the rear panel).
Power switch
Before turning on the M•Flex speaker, make sure that all sources such as mixer,
musical instruments or CD players have been turned on, and the input gain controls
have been turned down.
When shutting down the system, reverse the process, i.e. turn off the speaker and
then all external sources.
LED indicators
Note that on the front of the unit there is an additional:
• Blue LED that turns off when the unit is in standby waiting for a signal
• Red LED that indicates when the limiter is active
Blue AC power on
Green Receiving signal
Red Limiter active
To Next Page
Loading...