Introduction
7
The 15” unit is a unique construc-
tion that features a lightweight chas-
sis. The chassis is very open and
enables excellent coupling of the
diaphragm to the air in the cabinet.
It incorporates venting below the
spider to reduce power compression
and improve clarity. A special Soft-
Roll design is featured in the spider.
This design allows for more than +-
18mm excursion. A Kapton voice
coil former ensures excellent
mechanical stability. The 1” com-
pression driver incorporated a very
lightweight diaphragm and with 107
dB sensitivity the unit is more effi-
cient than many 2” drivers. But it
still has the advantage of a very
wide frequency response and runs
flat to 19 kHz. It is mounted behind
a 90 x 40 constant directivity horn
with excellent coverage control.
M
•
Flex
S
For stronger reproduction of frequencies
from 100 Hz and down, the M•Flex S is
designed to deliver the punchy kick from a
bass drum or a hard low-frequency bass line.
At the same time it contributes to an overall
increase of dynamics and sound pressure of
the M•Flex top-boxes. The 15” unit in
M•Flex S is a powerful construction that
features a lightweight chassis. The chassis is
very open and enables excellent coupling of
the diaphragm to the air in the cabinet. It
incorporates venting below the spider to
reduce power compression and improve
clarity. A special SoftRoll design is featured
in the spider. This design allows for more
than +-18mm excursion and extended sub
bass output. The 39 mm. voice coil former is
made of aluminium and ensures excellent
heat dissipation and very low power com-
pression. A strong Kapton voice coil former
ensures excellent mechanical stability. Digi-
tally powered the concept of a lightweight design in the entire M•Flex series is
maintained and an active crossover with hi-output link option ensures optimum
integration of M•Flex S with the rest of your M•Flex speakers.
M•Flex as separate
microphone
monitor
M•Flex 15 connected
via M•Flex S
high-pass out
To Next Page
Loading...