Controller Battery Level Display:
Motion Sensing Analog Function:
PROGRAMMING BUTTON MACRO DEFINITION
Four indicator lights display the controller's battery level in real-time.
During pairing and some function adjustments, they temporarily function
as function indicators and return to battery level display after approximat
-ely 2 seconds.
The controller has a built-in 600mAh battery with a battery life of 5-8 hours.
1. With the controller connected, press the Fn+M1/M2/M3 (pressing the rig
-ht trigger all the way down triggers M1/M2/M3) / M4 (pressing the left tr
-igger all the way down triggers M4). The decorative light strip will flash
continuously, indicating that the gamepad has entered recording mode.
If it does not flash, please repeat this step.
2. Record the required function buttons in order. A/B/X/Y/Up/Down/Left/
Right/L1/L2/R1/R2 and left and right joysticks are supported.
3. After the setting is completed, short press the M1 button. The light strip
backlight of the controller stops flashing and returns to the previous mo
-de, indicating that the setup is complete.
Note: To clear the current macro definition：press FN+M1 while the contr
-oller is in operation. The light strip backlight of the gamepad will flash co
-ntinuously. Then press the M1 button again, and the light strip backlight
of the gamepad will stop flashing, clearing the current custom function.
Press Fn + R3 to enable/disable the motion sensing function of the control
-ler’s right analog stick.
To program macro buttons:
To Next Page
Loading...
