MacroAir Technologies 4 - Temp;Humidity Sensor Installation (Optional)

To Next Page

To Previous Page

14 Network Installation

Controller 4 Operation Manual 90-30027-00 Rev A-01 Date: 032720

Temperature/Humidity Sensor Installation (Optional)

Black (From Power Supply) ...................... Common

PINOUT: Black/White (From Power Supply) ......... 24VDC+

Blue (From Cat5E) ..................................... Net+

Blue/White (From Cat5E) ......................... Net-

Mounting: Ceiling or Floor Mounting

1. When mounting the temperature/humidity sensor at the

ceiling, mount at least 1ft [0.3 m] below the ceiling in the

same room where the fan/fans are placed. When mounting

the temperature/humidity sensor at the floor, mount the

sensor within 6ft [1.8m] of the ground in the room where the

fan/fans are placed. Use caution when placing the sensor

making sure not to place it where there is any contact with

direct sunlight. Each sensor has small mounting holes for

attachment with screws.

2. Once the sensor has been placed it can be wired into the network. Use the provided

110/120V power supply to power the temperature/humidity sensor and the blue,

blue/white, and brown wires from the CAT5e cable for communication. If there is enough

slack in the cable you can run the wiring directly in and out at the same point on the sensor.

3. Please refer to the wiring diagram. See pages 10-11 of this manual for proper stripping and

bean crimping of wires.

Related product manuals