Need help?Do you have a question about the MacroAir Technologies Controller 4 and is the answer not in the manual?
General| Brand | MacroAir Technologies |
|---|---|
| Model | Controller 4 |
| Category | Control Systems |
| Language | English |
Highlights hazards related to electric shock, explosion, and arc flash during installation and operation.
Instructions to avoid operating or installing damaged fans to prevent injury or equipment damage.
Guidance on proper maintenance, service, and contacting technical support for troubleshooting.
Describes the requirement for connecting MacroAir fans in a single daisy chain line.
Shows examples of incorrect network wiring configurations that should be avoided.
Demonstrates the correct way to wire fans in a network, emphasizing a single beginning and end.
Specifies that excess cable at connection points should not be coiled and should be limited in length.
Illustrates the process of creating a T-splice connection for CAT5 network cables.
Details the pin assignments for CAT5-B connectors used with MacroAir equipment.
Guidance on mounting the floor temperature sensor in the room for accurate readings.
Presents the dimensions and specifications of the controller's 2.8-inch LCD display.
Shows various views (front, rear, side, top, bottom) of the controller's physical enclosure with dimensions.
Provides contact information and procedures for obtaining warranty service from MacroAir.
To Next Page