© 2017 MacroAir Technologies Toll Free: 866 668 3247 Fax: 909 890 2313 www.macroairfans.com 14
Rev. Date 032217
The touchscreen may require additional setup before operating the fans. Please refer to the steps
below to properly configure your controller.
1. Power on the fans. The screen will illuminate as soon as power is supplied.
2. The screen will search for fans and take you to the home screen once the scan is complete.
3. AVD 370, AVD3-430, and AirVolution fans do not require further setup. If you only have these
fans on the network, set a speed and direction using the buttons on the home screen. AirVolution
fans will operate normally. AVD 370 and AVD3-430 fans will spin in reverse at a preset speed,
automatically determine the blade length, and resume operation at the speed and direction
commanded.
4. AVD3-450, 550 and 780 fans REQUIRE the blade size to be programmed in order to function
correctly. The blade size is set via the “Settings” (pg 19). Once the size is programmed into every
AVD3-450, 550 and 780 on the network, the fans can be operated normally.
Screen Setup
To Next Page
Loading...
Need help?
General